● Reset Mode

  • Function  Description
    To  determinate  the  default  Reset  Mode. 
    Reset  Mode  is  to  stop  voice  recording  and  turn  off  speaker. 



  • Option  or  Range  List
    Automatic  –  With  this  setting  any  loss  of  carrier  less  than  500ms  ensure  the  pager  will  stay  active  and  store  the  received  message.    If  the  loss  of  carrier  exceeds  500ms,    then  Delayed  N  Auto,  Delayed  N  Revert  or  Timeout  would  be  the  preferred  choice. 

    Delay  N  Auto-  Works  in  concert  with  the  Delay  Timer  setting  to  ensure  the  G1  stays  active  and  records  the  incoming  voice  message.    If  this  mode  is  chosen  for  the  Selective  Call  Function  mode,  once  the  voice  message  is  recorded  the  G1  goes  back  to  standby  awaiting  the  next  valid  2  tone  message.    If  chosen  for  the  Monitor  and  Scan  Function  Modes,  the  pager  will  stay  active  for  the  Delay  Timer  set  value  and  then  resume  either  monitoring  the  channel  or  scanning  channels. 

    Revert  –  If  selected  with  either  the  Selective  Call  or  Silent  Scan  Mode,  the  G1  will  automatically  begin  monitoring  the  channel  upon  receipt  of  a  voice  page.  If  the  received  voice  message  is  to  be  stored,  use  this  selection  only  if  the  loss  of  carrier  during  the  page  does  not  exceed  500ms. 

    Time  Out  –  Sets  the  duration  the  G1  will  stay  active  and  store  messages.    It  is  possible  with  this  setting  that  the  G1  will  go  into  the  Standby  mode  before  the  voice  message  is  completed. 

    Manual  –  The  G1  will  continue  to  record  until  the  Reset  keybutton  is  depressed. 

    Delay  N  Revert  -  Works  in  concert  with  the  Delay  Timer  setting  to  ensure  the  G1  stays  active  and  records  the  incoming  voice  message.    This  is  only  available  for  the  Selective  Call  and  Silent  Scan  Function  Modes  and  upon  loss  of  carrier  the  G1  begins  monitoring  the  channel. 

    None-Default  setting  only.